Chemisorption of Exchange‐Coupled [Ni2L(dppba)]+ Complexes on Gold by Using Ambidentate 4‐(Diphenylphosphino)benzoate Co‐Ligands

A new strategy for the fixation of redox‐active dinickel(II) complexes with high‐spin ground states to gold surfaces was developed. The dinickel(II) complex [Ni₂L(Cl)]ClO₄ ( 1 ClO₄), in which L^2? represents a 24‐membered macrocyclic hexaaza‐dithiophenolate ligand, reacts with ambidentate 4‐(diphenylphosphino)benzoate (dppba) to form the carboxylato‐bridged complex [Ni₂L(dppba)]⁺, which can be isolated as an air‐stable perchlorate [Ni₂L(dppba)]ClO₄ ( 2 ClO₄) or tetraphenylborate [Ni₂L(dppba)]BPh₄ ( 2 BPh₄) salt. The auration of 2 ClO₄ was probed on a molecular level, by reaction with AuCl, which leads to the monoaurated Ni^II₂Au^I complex [Ni^II₂L(dppba)Au^ICl]ClO₄ ( 3 ClO₄). Metathesis of 3 ClO₄ with NaBPh₄ produces [Ni^II₂L(dppba)Au^IPh]BPh₄ ( 4 BPh₄), in which the Cl^? is replaced by a Ph^? group. The complexes were fully characterized by ESI mass spectrometry, IR and UV/Vis spectroscopy, X‐ray crystallography ( 2 BPh₄ and 4 BPh₄), cyclic voltammetry, SQUID magnetometry and HF‐ESR spectroscopy. Temperature‐dependent magnetic susceptibility measurements reveal a ferromagnetic coupling J=+15.9 and +17.9 cm^?1 between the two Ni^II ions in 2 ClO₄ and 4 BPh₄ (H=?2 JS₁S₂). HF‐ESR measurements yield a negative axial magnetic anisotropy (D<0), which implies a bistable (easy axis) magnetic ground state. The binding of the [Ni₂L(dppba)]ClO₄ complex to gold was ascertained by four complementary surface analytical methods: contact angle measurements, atomic‐force microscopy, X‐ray photoelectron spectroscopy, and spectroscopic ellipsometry. The results indicate that the complexes are attached to the Au surface through coordinative Au? P bonds in a monolayer.     

Quantum dot–NBD–liposome luminescent probes for monitoring phospholipase A2 activity

In this paper we describe the fabrication and characterization of new liposome encapsulated quantum dot–fluorescence resonance energy transfer (FRET)-based probes for monitoring the enzymatic activity of phospholipase A_2. To fabricate the probes, luminescent CdSe/ZnS quantum dots capped with trioctylphosphine oxide (TOPO) ligands were incorporated into the lipid bilayer of unilamellar liposomes with an average diameter of approximately 100 nm. Incorporating TOPO capped quantum dots in liposomes enabled their use in aqueous solution while maintaining their hydrophobicity and excellent photophysical properties. The phospholipid bilayer was labeled with the fluorophore NBD C₆-HPC (2-(6-(7-nitrobenz-2-oxa-1,3-diazol-4-yl)amino)hexanoyl-1-hexa decanoyl-sn-glycero-3-phosphocholine). The luminescent quantum dots acted as FRET donors and the NBD dye molecules acted as FRET acceptors. The probe response was based on FRET interactions between the quantum dots and the NBD dye molecules. The NBD dye molecules were cleaved and released to the solution in the presence of the enzyme phospholipase A_2. This led to an increase of the luminescence of the quantum dots and to a corresponding decrease in the fluorescence of the NBD molecules, because of a decrease in FRET efficiency between the quantum dots and the NBD dye molecules. Because the quantum dots were not attached covalently to the phospholipids, they did not hinder the enzyme activity as a result of steric effects. The probes were able to detect amounts of phospholipase A₂ as low as 0.0075 U mL^?1 and to monitor enzyme activity in real time. The probes were also used to screen phospholipase A₂ inhibitors. For example, we found that the inhibition efficiency of MJ33 (1-hexadecyl-3-(trifluoroethyl)-sn-glycero-2-phosphomethanol) was higher than that of OBAA (3-(4-octadecyl)benzoylacrylic acid).     

Synthesis and characterisation of Ni(II), Cu(II), and Zn(II) complexes with an acyclic Mannich base functionalised with thioglycolate moiety

New complexes ML(CNS)·nH₂O [M = Ni, n = 0.5; M = Cu, n = 4.5; M = Zn, n = 0.5, HL: 6-mercapto-(1,4,8,11-tetraazaundecanyl)-6-carboxylic acid)] have been synthesised, chemical analysed, and characterised by different spectroscopic techniques (IR, UV–Vis–NIR, ¹H NMR, EPR, ESI–MS), and magnetic measurements. Based on the IR spectra a dinuclear structure with the 1,3-CSN coordination was proposed for Ni(II) and Cu(II) complexes. The dinuclear structure of Cu(II) complex is also consistent with both magnetic behaviour and EPR spectrum. According to TG, DTG and DTA curves the thermal transformations are complex processes, including dehydration, Mannich base oxidative degradation and thiocyanate decomposition. The final product of decomposition is the most stable metallic oxide, as XRD data indicates. The new complexes were also screened for their microbicidal and antibiofilm properties.     

Out‐of‐Water Constitutional Self‐Organization of Chitosan–Cinnamaldehyde Dynagels

An investigation of the constitutional adaptive gelation process of chitosan/cinnamaldehyde ( C / Cy ) dynagels is reported. These gels generate timely variant macroscopic organization across extended scales. In the first stage, imine‐bond formation takes place “in‐water” and generates low‐ordered hydrogels. The progressive formation of imine bonds further induces “ out‐of‐water” increased reactivity within interdigitated hydrophobic self‐assembled layers of Cy , with a protecting environmental effect against hydrolysis and that leads to the stabilization of the imine bonds. The hydrophobic swelling due to Cy layers at the interfaces reaches a critical step when lamellar self‐organized hybrids are generated (24 hours). This induces an important restructuration of the hydrogels on the micrometric scale, thus resulting in the formation of highly ordered microporous xerogel morphologies of high potential interest for chemical separations, drug delivery, and sensors.     

Thermal degradation of a styrenated unsatured polyester resin

The isothermal and non-isothermal degradation of a typical styrenated phthalic acid-maleic acid-propylene glycol polyester were measured. Non-isothermal and isothermal kinetic analyses were performed on the various degradation steps observed. The values of the non-isothermal and the isothermal kinetic parameters are in good agreement.     

The influence of titanium dioxides,alumina and calcium carbonate on the thermal stability of barium carbonate

Using static oxygen-bomb calorimetry, the standard enthalpies of combustion of the 2,4-and 2,6-isomers of dinitrophenol have been determined as ?2697.22 and ?2723.08 ± 3.18 kJ mole^?1, respectively. Standard enthalpies of formation have been calculated as ?235.50 and ?209.64 ± 3.27 kJ mole^?1, respectively.     

Amperometric Detection of 4‐Chlorophenol on Two Types of Expanded Graphite Based Composite Electrodes

The assessment of an expanded graphite‐Ag‐zeolite‐epoxy composite (EG‐Z‐Ag‐Epoxy) electrode for the determination of 4‐chlorophenol (4‐CP) is described and compared to the corresponding expanded graphite‐epoxy composite (EG‐Epoxy) electrode. Cyclic voltammetry was used to characterize the electrochemical behavior and determination of 4‐CP at both electrodes in 0.1 M Na₂SO₄ and 0.1 M NaOH supporting electrolytes. A substantial enhancement of sensitivity for the determination of 4‐CP at the EG‐Z‐Ag‐Epoxy electrode was reached by applying a chemical preconcentration step prior to voltammetric quantification. Also, under these last conditions the lowest limit of detection of 1 μM illustrates the analytical versatility of this electrode in a concentration range where aquatic 4‐chlorophenol pollution is known to occur.     

Plastic Antibodies for Cosmetics: Molecularly Imprinted Polymers Scavenge Precursors of Malodors

Molecularly imprinted polymers (MIPs) are synthetic antibody mimics capable of specific molecular recognition. Advantageously, they are more stable, easy to tailor for a given application and less expensive than antibodies. These plastic antibodies are raising increasing interest and one relatively unexplored domain in which they could outplay these advantages particularly well is cosmetics. Here, we present the use of a MIP as an active ingredient of a cosmetic product, for suppressing body odors. In a dermo‐cosmetic formulation, the MIP captures selectively the precursors of malodorous compounds, amidst a multitude of other molecules present in human sweat. These results pave the way to the fabrication of a novel generation of MIPs with improved selectivities in highly complex aqueous environments, and should be applicable to biotechnological and biomedical areas as well.     

Liquid crystalline phases and their dispersions in aqueous mixtures of glycerol monooleate and glyceryl monooleyl ether

The aqueous phase behavior of mixtures of 1-glycerol monooleate (GMO) and its ether analogue, 1-glyceryl monooleyl ether (GME) has been investigated by a combination of polarized microscopy, X-ray diffraction, and NMR techniques. Three phase diagrams of the ternary GMO/GME/water system have been constructed at 25, 40, and 55 degrees C. The results demonstrate that the increasing amount of GME favors the formation of the reversed phases, evidenced by the transformation of the lamellar and bicontinuous cubic liquid crystalline phases of the binary GMO/water system into reversed micellar or reversed hexagonal phases. For a particular liquid crystalline phase, increasing the GME content has no effect on the structural characteristics and hydration properties, thus suggesting ideal mixing with GMO. Investigations of dispersed nanoparticle samples using shear and a polymeric stabilizer, Pluronic F127, show the possibility of forming two different kinds of bicontinuous cubic phase nanoparticles by simply changing the GMO/GME ratio. Also NMR self-diffusion measurements confirm that the block copolymer, Pluronic F127, used to facilitate dispersion formation, is associated with nanoparticles and provides steric stabilization.